EPIP603 Solar Charge Controller for Solar System with Digital and symbol display,which is the third generation of controllers EPSOLAR characterized by high quality and reliability. Added new features and protection with the use of advanced technologies. The controller provides long battery life and better job of photovoltaic systems. The controller sets new standards for reliability and self-diagnosis of such devices.

Distinctive feature of these controllers is the ability to store and transfer data through the RS-232. Data is stored in the last 30 days.

STANDARD FEATURES:
Version controllers: 30, 40, 50 or 60 amps
autoselection 24/48 B, positive or negative common wire
Determination of charge (State of charge - SOC) and the regulation of this parameter
Installing the battery capacity, charge 4 modes (fast, leveling, supporting, PWM)
Automatic load reconnection, manual load break switch
Automatic selection of operating voltage depending on the connected battery (24/48 V)
Temperature compensation
Large LCD display: SOC as a fuel sensor, all system parameters in digital form, the mapping of the system in the form of symbols
Full protection circuits, electronic fuse
All parameters are set using the 4 buttons
Options include automatic load - from dawn to dusk, from sunset plus a specified number of hours, manual transmission
Built-in clock, time display on the display.

ELECTRONIC PROTECTION:
Short-circuiting the SB and the load
Overloading of the SB and the load
Incorrect polarity protection from discharge AB through Sat night
Shutdown overvoltage
The load is protected Surge
Automatic recovery after operation of all defenses

EPIP603 Solar Charge Controller Regulator Data Sheet

Models equipped with 24/48V voltage offset end temperature sensors and computer programs for communication. RS-232 is not included.

Note: All voltages are specified for the voltage of 24 V. For 48V to be multiplied by 2.