Juta CMP24(16A,20A,24A) solar charge controller,it`s often used in 12V or 24V solar system. CPU controlled CMP24 (16A-24A) solar charge controller is able to adjust the charge current and decide if to supply the loads electricity according to the voltage of battery.

Package including:
1.1X CMP24 charge controller
2.1X Thermoscope
3.1X USERS` Manual

Protection:

1. Keep the battery on full voltage condition.
2. Over-charging/discharging Protection.
3. Prevent supplying electricity from the battery to solar panels during nights.
4. Reverse Polarity Protection for Battery
5. Reverse Polarity Protection for Solar panels
6. Overload protection .
7. Short circuit Protection
8. Protection from the lightning strike
   
   

LCD Screen
LCD Screen show the voltage of battery, charging current and current of loads in turn in every 5 seconds.

Thermoscope(Standard Accessory)
Installation：Plug the thermoscope into the socket (top) of controller before running of controller, and then connect battery with the controller. The thermoscope will normally work after one minute. (Operate as indicated in the fourth Chapter, the environmental temperature of controller will be available on LCD).
When controller starts up, controller will self-setup the Charging-off voltage, the Load-off voltage and the Load-on voltage according to the voltage of battery. These default parameters are setup as the standard environment temperature is 25℃.

Circuit diagram

Connect “+” and “-”poles of solar panel with the correct ports on the controller (the first and second ports from the left).
Connect “+” and “-” poles of battery with the correct ports on the controller (the third and fourth ports from the left).
Connect “+” and “-” poles of load with the correct ports on the controller (the fifth and sixth ports from the left).

CMP24 solar charge controller regulator circuit diagram
Data Sheet